2-Body, Roll-In Morgue Cooler 2 High x 1 Wide Configuration Temperature Range: 2-6°C [35-42°F] Dimensions - 7?-10 1/2" Deep X 3-3” Wide X 6’-1/4”" High [2400 mm X 991 mm x 1835 mm] Exterior Finishes Front: 20 Ga. (.91mm) Type 304 Polished Stainless Steel, #4 Finish Sides/Back/Top: .032" [.81mm] Stucco Embossed Aluminum Door: 20ga [.91mm] Type 304 Stainless Steel, #4 Finish Interior Finishes Walls/Ceiling: .032" [.81mm] Stucco Embossed Aluminum Floor: 20 ga [.91mm] Galvanized Steel Insulation - Nominal 4" [102mm] Foamed In Place Polyurethane Insulation Roll-In Door Construction (Quantity 1) Door Heater - Perimeter Anti-Sweat Device, Replaceable, 115 Volts/ 60 Hertz/ 1 Phase Hardware - Edge Mount Type, Chrome Plated, Adjustable Chrome Plated Keyed Latch with Inside Safety Release Card Holder, 1 per body Gasket - Extruded Vinyl, Welded Corners, Dart Style, Replaceable Refrigeration - Self-Contained Combination Condensing Unit/Evaporator Package System o Refrigerant - R-404a o Air Cooled o Approximately 2900 BTUH @ 95°F [35°C] Ambient o 115 Volts/ 60 Hertz/ 1 Phase o Unit Is Factory Built Up, Evacuated, Charged, Wired And Run Tested o Blower Coil, Automatic Off-Cycle Defrost o EC Motor(s) on Evaporator o Digital Temperature Controller o Evaporator Drain Pan - no drain line required