6-Body, Roll In Morgue Cooler 2 High x 3 Wide Configuration Temperature Range: 2-6°C [35-42°F] Dimensions - 7?-10 1/2" Deep 9’-1 1/2” Wide X 6’-2 " High [2400 mm X 2781 mm x 1880 mm] Exterior Finishes Front: 20 Ga. (.91mm) Type 304 Polished Stainless Steel, #4 Finish Sides/Back/Top: .032" [.81mm] Stucco Embossed Aluminum Door: 20 Ga [.91mm] Type 304 Stainless Steel, #4 Finish Interior Finishes Walls/Ceiling: .032" [.81mm] Stucco Embossed Aluminum Floor: 20 Ga [.91mm] Galvanized Steel Insulation - Nominal 4" [102mm] Foamed In Place Polyurethane Insulation Roll-In Door Construction (Quantity 3) Door Heater - Perimeter Anti-Sweat Device, Replaceable, 115 Volts/ 60 Hertz/ 1 Phase Hardware - Edge Mount Type, Chrome Plated, Adjustable Chrome Plated Keyed Latch with Inside Safety Release Card Holder, 1 per body Gasket - Extruded Vinyl, Welded Corners, Dart Style, Replaceable Cart Guide (Quantity 3) - Floor Mounted, 18 GA Type 304 Stainless Steel Condensing Unit 1 H.P. Hermetically Sealed, Indoor Type Refrigerant - R-404a Air Cooled Approximately 9,800 BTUH @ 95°F [35°C] Ambient 208-230 Volts/ 60 Hertz/ 1 Phase Unit Is Factory Built Up And Run Tested Evaporator Unit Blower Coil, Automatic Off-Cycle Defrost 115 Volts/ 60 Hertz/ 1 Phase EC Motors