8-Body, Roll-In Morgue Cooler 2 High x 4 Wide Configuration Temperature Range: 2-6°C [35-42°F] Dimensions - 7?-10 1/2" Deep X 12’-1” Wide X 6’-4" High [2400 mm X 3683 mm X 1930 mm] Exterior Finishes Front: 20 Ga. [0.91mm] Type 304 Polished Stainless Steel, #4 Finish Sides/Back/Top: .032" [0.81mm] Stucco Embossed Aluminum Door: 20 Ga. [0.91mm] Type 304 Stainless Steel, #4 Finish Interior Finishes Walls/Ceiling: .032" [0.81mm] Stucco Embossed Aluminum Floor: 20 Ga. [0.91mm] Galvanized Steel Insulation - Nominal 4" [102mm] Foamed In Place Polyurethane Insulation Roll-In Door Construction (Quantity 4) Door Heater - Perimeter Anti-Sweat Device, Replaceable, 115 Volts/ 60 Hertz/ 1 Phase Hardware - Edge Mount Type, Chrome Plated, Adjustable Chrome Plated Keyed Latch with Inside Safety Release Card Holder, 1 per body Gasket - Extruded Vinyl, Welded Corners, Dart Style, Replaceable Refrigeration - Self-Contained Combination Condensing Unit/Evaporator Package System Refrigerant - R-404a Air Cooled Approximately 13.570 BTUH @ 95°F [35°C] Ambient 208-230 Volts/ 60 Hertz/ 1 Phase Unit Is Factory Built Up, Evacuated, Charged, Wired And Run Tested Blower Coil, Automatic Off-Cycle Defrost EC Motor(s) on Evaporator Digital Temperature Controller Evaporator Drain Pan - no drain line required Cart Guide (Quantity 4) - Floor Mounted, 18 Ga. Type 304 Stainless Steel Sectional Construction Shipped Disassembled Shipping Weight - Approximately 4,200 Lb. [1,905 Kg]