M-TRACE MOBILE is a modern ECG register purposed for the private use by a patient at their home. Simple handling of the device allows a patient to conduct the ECG test of similar quality as the one conducted by the clinical devices. Each M-TRACE MOBILE is remotely configured and controlled by a doctor and it can be updated from the central level. It also allows a doctor to remotely set up signal registration parameters and testing modes. M-TRACE MOBILE testing modes: Single test Event holter By the visual and audio indicators, M-TRACE MOBILE communicates incorrect contact between patient’s skin and electrodes. GSM/GPRS module of the class 12, that works in the GSM 850/900/1800/1900 MHz quad band Voice communication Automatic deletion of the test result after a receipt of confirmation that it was collected and registered by the System. Remote configuration of parameters of the device: sampling frequency, activated filters, registration time Test result sent to the System in the ECG-SCP format accordingly with the EN1064 norm Communication with the System directly by the http or https protocol Possibility of remote firmware software updates ECG leads: 6 standard I,II,III, avR,aVL,aVF, cable with 3 or 4 leads Time of test record up to 60 seconds, remote set-up Battery: LI-jon 1100mAh Frequency range: min. 0,05 – 100 Hz. CMRR: >100 dB ( with a 4 leads cabel) Input impedance > 10M Range of steering > 12mVpp A/C, 24 bit converter Signal resolution – 0,5uV/bit Sampling frequency: 1000Hz, programmed from the System Digital filtration: 50Hz, 35Hz, 25Hz, isoline filter In case of lack of network: 40MB of testing memory